Category ""
ADVERTISING
I tried moving ports on version 4.8.14 and I cannot get it to work. I have moved ports in the past without any problems. I have been unable to figure out why. Is anyone having a similar problem? I posted in the UniFi community forums but no responses. Here is my system.properties file content: system.properties each unifi instance requires a set of ports: unifi.http.port=8080 # device inform ...
I have an unifi USW Pro 48, This is the first time I am configuring VLANs on unifi. but my first issue is that when I plug in the uplink fiber I get no through traffic to the next switch. if I plug it into the current switch (TP-Link) it works as expected. the Switch sits on an infrastructure VLAN on 10.19.0.x it has a static IP, like all the rest of the switches on the network. The switch ...
Good afternoon, all! Perhaps someone can shed some light on why a firewall config on my UniFi Security Gateway isn’t working as expected. I’ll try to be brief. Goal: prevent TCP/UDP port 53 (DNS) from traversing the firewall EXCEPT from my two local DNS servers. They need unfettered access for fallback/root hint servers to function. Prerequisites: Created port group called “DNS traffic ...
Ensure Ports 80 and 443 are open on your firewall and forwarded to your Unifi Cloud Key. Let Encypt requires these ports to be open as it attempts to verify connectivity to your device before it will issue a certificate. These ports are also required to be open for renewals of your certificate.
On a Unifi switch interface AggrInt1 was defined and ports 21-22 were aggregated. AggrInt1 is connected to a FortiGate that also have an aggregated interface. Interface AggrInt2 was created with ports 19-20 and connected to an aggregated interface in a Cisco switch.
A wiring contractor connected some Ubiquiti UAP AC Pro AP’s in a warehouse. Only the Main Ethernet port of the AP’s should have been used in this installation. One of the AP’s is not working properly. Would connecting the AP via the Secondary port instead of via the Main port on the AP cause the malfunction or are these two ports interchangeable in this situation? The ceiling of the ...
Hi, First time posting 🙂 We use Unifi AP’s that are behind a sonicwall. How do I open port 8080 to allow the adoption to the unifi cloud controller. When I try to nmap -p 8080 it is being blocked. So far I have setup a custom service object for 8080 but I am not sure where to proceed from here. I just need port 8080 open inbound/outbound to the entire LAN???
We were looking at the Ubiquiti UniFi Switch 48 500W switch as we are installing UniFI access points throughout the building. This switch has 48 1GB/s RJ45 ports. It also has two SPF ports and two SPF+ ports.
Hi Spiceworks Community We have a network infrastructure based on 2 Ubiquiti UniFi 48 ports switches and a Ubiquiti UniFi Security Gateway. The Gateway went dead (the console green light stays on and no other function or response from the router) and we are looking to buy a replacement. Since we bought the gateway we acquired two more Internet access for load balance and fault tolerance. Now ...
What I do for my own clients is that I run a Cloud Key in my home office to manage my own devices, plus I have my WatchGuard firewall accept inbound ports 3478 UDP and 8080 TCP (but ONLY from my clients’ IP addresses or FQDN…it’s not open to the whole world) and then the WatchGuard forwards those ports to the Cloud Key that is my UniFi ...